Rock Systems Portable Pugmill Plant, Model 802-RSI complete as follows:

a. 36" wide x 33’ long pugmill feed conveyor with Weg 10 h.p. electric motor, Dodge TXT3 shaft mount speed reducer with internal backstop, v-belt drive and OSHA drive guard; Dodge 14" diameter rubber lagged head pulley; Dodge 12" diameter self-cleaning tail pulley; screw take-up assemblies; Dodge SCM pillow block bearings; OSHA tail terminal guard; head pulley nip guards; CEMA "C" troughing and return idlers with 5" diameter rolls; 3 ply conveyor belting with 3/16" x 1/16" rubber covers; Flexco 140 mechanical belt splice; Flexco Rockline belt scraper installed.

b. Belt-Way model 100 belt scale with micro-computer mounted in a NEMA 4X waterproof enclosure displaying feed rate, total weight and belt speed; dual strain-gage load cell mounted in weighbridge; digital belt speed sensor; I/O board and calibration weights.

c. Eagle Iron Works 36" diameter x 8’-6" long pugmill with 75 h.p. electric motor; shaft mount speed reducer; v-belt drive and drive guard; Ni-Hard paddles; receiving hopper; hinged cover over mixing chamber; flow meter and spray bar.

d. Portable trailer constructed of heavy duty wide flange beams which are braced for optimum rigidity; single axle chassis with dual 11 x 22.5 tires, air brakes, king pin, rear lighting, mud flaps and blocking pads; includes pugmill discharge chute and walkway with handrails on one side of pugmill with access ladder.

e. Electric motor control panel with starters for all above electric motors pre-wired to each electric motor.

f. One rust inhibitor prime coat and one finish coat gray paint for all equipment; one finish coat safety yellow paint for all guarding.

This unit can be matched up to any of our feeders such as a front end loader hopper with belt feeder or any of our portable 2 bin, 3 bin or 4 bin blending hoppers.