Rock Systems Portable Low Profile End Dump Truck Unloader, Model 111-LP complete as follows:
a) Low profile truck dump 12' long x 4'-9" wide x 24" tall, hopper and skirtboards with adjustable REMA 1/2" x 6" skirtboard rubber; side boards; removable backboard which can be installed on either side of the unit; 1" x 6" rubber bumpers.
b) 48" wide discharge conveyor complete with 25 h.p. electric motor, Dodge TXT6 shaft mount reducer with internal backstop; v-belt drive and OSHA drive guard; 18" rubber lagged head pulley mounted on 3-7/16" shafting with Dodge Type "E" bearings; 8" snub pulley mounted on Dodge SCM bearings; 12" self-cleaning tail pulley mounted on 2-7/16" shafting with Dodge SCM bearings; screw take-up assemblies; 3 ply conveyor belting with 3/16" x 1/16" rubber covers; CEMA "C" flat belt idlers mounted on close centers at load point followed by CEMA "C" 35 degree troughing idlers mounted on 4' centers; CEMA "C" return idlers mounted on 10' centers; vertical curve with hold down wheel; Flexco Rockline belt scraper. Belt speed setup for 200 feet per minute; return idler guards.
c) Discharge hood with A/R liners.
d) Single axle chassis with brakes, lights and mud flaps; pintle type tow hitch; landing legs.
e) One rust inhibitor prime coat and one finish coat gray paint for all equipment; one finish coat safety yellow paint for all guarding.
Associated Files
- 111-LP General Arrangement Drawing
Request Information
By providing a valid email address and clicking Submit Request, you are agreeing to be added to Rock Systems' email newsletter list. Your contact information will not be shared with anyone outside of Rock Systems. You can opt out of the newsletter list at any time by using the unsubscribe link found in the newsletters.
